TACKLIFE 18PCS Screw Extractor with Separated Burnishing Bits and Extractors, Magnetic Extension Bit Holder and Socket Adapter for Damaged Bolts or Screws 2-12mm, Hardness 62HRC, DSE01
Related posts
Feature
Industrial Grade - Tacklife 18pcs damaged screw extractor set covers higher possibility of extraction for more broken screws or bolts of different sizes(2-12mm) and the self-centering drill tips can work on jagged, uneven rough breaksSmartDesign - Working together with an extension bit holder and a socket adapter, burnishing bits and extracting bits designedseparatelyenables casual changes of the bits without flipping, timeless and effortless for work
Powerful Fittings Supply - Extension bit holder(6.35mm,1/4'') and socket adapter (4mm, 5/32'' ) of the screw remover set suits all the brand household electric drills; Magnetism inside the holder and adapter keeps the bits from dropping, so do small bolts or screws
Adequate Quality - S2 material (hot work die steel) with maximize rust and corrosion protection, hardness can reach to 62HRC for strength, flexibility and durability; Serrations on extractor(collet) result in greater torque for hard to remove bolts
Notes - Extension bit holder should be used to big size bits1/4'' (#1~#4), adapter for the small ones 5/32'' (#5~#8), and adapter can be installed into the extension bit holder when needed; The drilling bit has its tailored extractor, please not mix them up; Please adjust drill to the slowest speed, less than 400RPM will be enough
Description
Fantastic Features
A wideassortmentofbolt or screw heads can be covered (Pozis, Phillips, Slotted, Torxs, Square, Hexagons, Security Torx, etc.)
HandlingStubborn of stripped, broken, damaged, embedded, rusted and painted-over screws without any problem
S2 material and self-centering drill tips are precision engineered for multiple extractions and maximum performance
Wide range of screw or bolt sizes as follows:
#1 Remove Diameter 6~12mm
#2 Remove Diameter 5~10mm
#3 Remove Diameter 4~8mm
#4 Remove Diameter 3~5mm
#5 Remove Diameter 3.5~6.5mm
#6 Remove Diameter 3~5.5mm
#7 Remove Diameter 2.5~4.5mm
#8 Remove Diameter 2~3.5mm
Easy to Use
Separated burnishing (drilling) bits and extractor bits simplify the whole process, you don't need to flip the extractor and rotate the drill chuck again for extracting then
All the bits can be applied to any electric drills with or without the extension bit holder or Adaptor, depending on where the bolt is
Effortless switches of extension bit holder and socket adapter makes the little details of daily work enjoyable. No grinding or centre punching required.
A clip on the back of the tool case helps carry the small package everywhere you go and close at hand
Instructions of Usage
Change the speed of the electric drill under 400RPM, and press rotational switch reverse
For bolts on flat surface, install with or without the extension bit holder into the drill and fully twistthe drill chuckon; For bolts in acrampedspace, the extension bit holder will be obviously needed
Select a suitable drilling bit according to the specifications attached beside the bits with #1-8, then drilling a hole in the middle of the screw until the hole deep enough to be damaged
Install the correspondent size of the extractor(collet) and then remove the damaged screw counterclockwise until it is released